30-04-2021

Connect Cisco Anyconnect Vpn



Connect

Installing the VPN Client

Anyconnect

Please share the output of, when you connect using anyconnect sh vpn-sessiondb detail anyconnect post that apply the captures using the below command capture asp type asp-drop all. Perform a small file transfer over the VPN and then share the output of the capture using the command sh capture asp. Setting a connect failure policy: The connect failure policy determines whether the computer can access the internet if Always-On VPN is enabled and AnyConnect cannot establish a VPN session. See Set a Connect Failure Policy.

  1. Download the AnyConnect VPN client for Windows. Note: If you're using Microsoft Edge, the program will download as a 'sys_attachment.do' file. You will need to rename the file to 'sys_attachment.msi'
    • If you have the Windows Surface Pro X tablet with an ARM-based processor, you should download the AnyConnect VPN client for ARM64.
  2. Click Run on the Open File – Security Warning dialog box.
  3. Click Next in the Cisco AnyConnect Secure Mobility Client Setup dialog box, then follow the steps to complete the installation. NOTE: We recommend you un-check everything (Web Security, Umbrella, etc) except for the VPN and the Diagnostic and Reporting Tool (DART). This will give you a minimal install. The other features are not supported so there's no need to install them.

Starting the VPN Client

Configure
  1. Go to Start->Programs->Cisco->Cisco AnyConnect Secure Mobility Client to launch the program.
  2. Enter vpn.uci.edu in the Ready toConnect to field, then press the Connect button.
  3. Select your desired connection profile from the Group drop-down menu:
    • UCIFULL – Route all traffic through the UCI VPN.
      • IMPORTANT: Use UCIFULL when accessing Library resources.
    • UCI – Route only campus traffic through the UCI VPN. All other traffic goes through your normal Internet provider.
  4. Enter your UCInetID and password, then click OK.
  5. A banner window will appear. Click Accept to close that window. You are now connected!

Disconnecting the VPN Client

Connect Cisco Anyconnect VpnConnect Cisco Anyconnect Vpn

How To Connect To Cisco Vpn Anyconnect

When you are finished using the VPN, remember to disconnect.

Configure Cisco Anyconnect Vpn On Router

  1. Right-click the AnyConnect client icon located in the system tray near the bottom right corner of your screen.
  2. Select Quit.